Introduction
Use this guide to replace the battery assembly in your APC uninterruptible power supply model SRT30000XLA.
What you need
-
-
Pull the left edge of the front bezel away from the device to release the plastic clip.
-
-
-
Use the cutout in the battery connector to pull it toward the right edge of the device and disconnect it.
-
-
-
-
Lift and rotate the battery connector to move it out of the way of the battery assembly.
-
-
-
Use a Phillips driver to remove the three 23 mm‑long screws securing the battery assembly.
-
-
-
Pull the battery assembly out of the housing until it stops at its first plastic tab.
-
Take your e-waste to an R2 or e-Stewards certified recycler.
To reassemble your device, follow these instructions in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our APC Smart-UPS SRT30000XLA Community for help.
Take your e-waste to an R2 or e-Stewards certified recycler.
To reassemble your device, follow these instructions in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our APC Smart-UPS SRT30000XLA Community for help.