Introduction
In this guide, we will show you how to remove and replace the Display Assembly.
What you need
-
-
Disconnect the display cable and the camera cable from their respective system board connectors.
-
-
-
Remove the six screws (three on each side) that secure the display assembly to the computer base.
-
-
-
Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from the routing guides.
-
-
-
-
Place the NEW display assembly in position and replace the six screws (three on each side) of the display assembly.
-
-
-
Route the Mini-Card antenna cables through the routing guides.
-
-
-
Connect the display cable and the camera cable to their respective system board connectors.
-
Cancel: I did not complete this guide.
2 other people completed this guide.