Introduction
In this guide, we will show you how to remove and replace the Hard Drive.
What you need
-
-
Remove the two screws securing the hard drive assembly to the system board.
-
-
-
Holding the connector end of the hard drive assembly, pull the hard drive assembly from the system board connector.
-
-
-
-
Press down on the hard drive at the non-connector end slot to remove the hard drive off the hard drive cage.
-
-
-
Place the NEW hard drive in the hard drive cage and press it down until it snaps into place.
-
-
-
Push down the hard drive assembly in place by aligning the hard drive connector with the system board connector.
-
-
-
Replace the two screws securing the hard drive assembly to the system board.
-
Cancel: I did not complete this guide.
2 other people completed this guide.