Dell Latitude E4200 LED Cover Replacement

Hezekiah Brown and one other contributor

Last updated on June 18, 2021

132

View statistics:

Past 24 Hours:

0

Past 7 Days:

2

Past 30 Days:

4

All Time:

132

0

No one has left comments on this guide. Will you be first?

Go to comments

0

No one has marked this guide "completed." Will you be the first?

Mark complete

0

No one has favorited (and subscribed to) this guide. Will you be the first?

Add favorite

1 - 3 minutes

Rough estimate of how long this takes. (Use this to plan your day, not to feel judged.)

Easy

Difficulty rating: Easy! Minimal disassembly, using only basic tools.

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide's procedures crystal clear.

Community-Contributed Guide

An awesome member of our community made this guide. It was not created by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

+1 more

Step 1 Remove the battery from the computer.
• Shut down your computer. Disconnect all power sources before opening the computer cover or panels.
• Remove the battery from the computer.
Step 2 Open the display all the way.

• Open the display all the way (160 degrees).
• To avoid damaging the LED cover, do not lift the cover on both sides simultaneously. Removing the LED cover in a different way than described may cause the plastic to break.
Step 3 Follow step below for information on how to take apart hinge cover.
• Starting on the right side of the computer, use a plastic scribe (inserted into the indent) to pry up the hinge cover. Lift the bottom edge of the cover away from the keyboard going from the right to the left, and then pull the cover up and away from the display to remove it.
Step 4 Install LED Cover.
• Before installing the LED cover, ensure that all cables are routed correctly. Improper routing of the cables can cause damage to the cables.
• Insert the tabs on the top edge of the cover into the slots under the bottom edge of the display.
• Press from left to right until the cover snaps into place, ensuring that the edges of the cover line up with those on the palm rest.

Author

with 1 other contributor

Hezekiah Brown

Member since: 02/11/21

6,169 Reputation

49 Guides authored

Badges: 10

• 
• 
• 

+7 more badges

Team

RampUP America, Inc. Member of RampUP America, Inc.

Community

43 Members

1,985 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview