Dell XPS 15 9510 Speakers Replacement

Introduction

Audio issues or sound failure in the Dell XPS 15 9510 indicates that the speakers located on either side of the laptop may need replacement. There are no special skills involved in the removal of the speakers.

Before using this guide, make sure to review the troubleshooting page to ensure that the speaker doesn't have any driver or any other issues.

Make sure to power off your laptop completely and disconnect from any external power source before beginning the process.

What you need

Step 1 Lower Case

Dell XPS 15 9510 Speakers Replacement, Lower Case: step 1, image 1 of 1

Make sure the laptop is powered off and unplug all cables before beginning any repair.
Remove eight 3 mm screws from the underside of the case using a T5 Torx screwdriver.

Edit

Step 2

The metal case of the XPS 15 9510 is extremely sharp, so be careful not to run your fingers along the edge when disassembling the laptop.
Wedge the case apart with a nylon spudger.
If the plastic one isn't possible to insert, use the metal spudger to carefully create a small gap first.
Slide spudger along each side of the laptop

Edit

Step 3

The metal case of the XPS 15 9510 is extremely sharp, so be careful not to run your fingers along the edge when disassembling the laptop.
Lift the back panel of the laptop off and set it aside.

Edit

Step 4 Speakers

Dell XPS 15 9510 Speakers Replacement, Speakers: step 4, image 1 of 3

Dell XPS 15 9510 Speakers Replacement, Speakers: step 4, image 2 of 3

Dell XPS 15 9510 Speakers Replacement, Speakers: step 4, image 3 of 3

Remove the 4 pieces of black tape holding the speaker wire in place.

Edit

Step 5

Remove the four 2.5 mm screws holding the speakers in place using a Phillips #0 screwdriver.

Edit

Step 6

Tool used on this step:

Tweezers

$4.99

Buy

Lift the black tape that covers the power supply pin plug.
Remove the plug using a small pair of tweezers. Be sure to not damage any wiring.

Edit

Step 7

Lift the speakers up from the securing pins.

Edit

Step 8

Begin removing the wire from the track on the computer body.
Now the speakers will be fully disconnected from the computer.

Edit

Conclusion

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.