Disassembling Samsung Galaxy S Blaze Whole Device

Introduction

This guide allows users of the Samsung Galaxy S Blaze to take the phone apart. You will need to be careful with the screws that are inside the device, the screws will strip easily. To properly disassemble the phone you will need a Phillips Head screw driver size 00 and a flat wedge opening device.

What you need

Step 1 Device

Disassembling Samsung Galaxy S Blaze Whole Device, Device: step 1, image 1 of 1

Remove the back plate.

Edit

Step 2

Remove the battery from the device.

Edit

Step 3

Use a Phillips head screwdriver size 00.
Remove the 4mm screws from the frame.
The eight screws are all the same size.

Edit

Step 4

Remove the frame from the phone by using the blue plastic opening tool.
Work around the phone with the tool until the frame is off.
You may need to use a bit of force to pry off the frame.

Edit

Step 5

The volume rocker is attached to the frame by two plastic prongs.
Unhook the prongs from the frame and remove the volume rocker.

Edit

Step 6

The SD card slot is held in place by a small tab.
Unhook the tab of the SD card slot, from the frame of the phone.

Edit

Step 7

The power button is attached to the phone with two prongs.
Unhook the prongs of the power button from the frame of the phone.

Edit

Step 8

Disassembling Samsung Galaxy S Blaze Whole Device: step 8, image 3 of 3

4 ribbon cable connectors hold the motherboard to the phone.
The first 3 are all on one side.
Use the blue plastic opening tool to unlatch the wire ribbons from the motherboard.