GoPro Hero3+ Silver Edition Image Sensor Replacement

Last updated on May 31, 2021

3 - 8 minutes

Easy

Introduction

The image sensor is a vital part of your GoPro. However, don't fear if it has broken, this guide will bring your device back to life!

Parts

Tools

Push the tab on the back of the device left to remove the plate covering the battery.

Insert a plastic opening tool in between the front face plate and the black housing.
Make sure you insert the plastic opening tool next to the microSD card slot. There is a small gap that will help separate the face plate.

Continue to use the plastic opening tool and separate the front face plate from the rest of the device.
There is adhesive that helps attach the front face plate. Some extra prying may be required to separate the face plate, but do not use excessive force.

Locate the four 8.1mm PH00 screws on the corners of the GoPro and unscrew them using the phillips screwdriver.
Gently remove the motherboard by using a plastic opening tool to pry it out of the housing.
Be careful not to damage the ribbon cable connected to the GoPro housing and motherboard.