Introduction
Use this guide to replace the chuck on your Milwaukee 2704-20 Hammer Drill (identified as M18 FUEL™ 1/2" Hammer Drill/Driver, Serial Number G73A). The tools required to complete this task and any additional information is listed in this document by Milwaukee.
What you need
-
-
Rotate the chuck counterclockwise until it stops rotating.
-
Inside the chuck, the “chuck screw” (M8.0 x 1 LH T-40 Chuck Screw) should now be revealed.
-
-
-
-
Go read page 2 of this document with the correct instructions. https://documents.milwaukeetool.com/54-2...
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
UMass Dartmouth, Team 2-1, Petersen Spring 2023 Member of UMass Dartmouth, Team 2-1, Petersen Spring 2023
UMASSD-PETERSEN-S23S2G1
4 Members
7 Guides authored
