Milwaukee 2704-20 Control Switch Replacement

Introduction

This guide is about how to replace a Control Switch for Milwaukee 2704-20 Drill. You will need to use the Milwaukee 2704-20 Disassembly Guide first in order to replace the control switch.

What you need

Step 1 Outer Case

Milwaukee 2704-20 Control Switch Replacement, Outer Case: step 1, image 1 of 2

Milwaukee 2704-20 Control Switch Replacement, Outer Case: step 1, image 2 of 2

Remove the battery from the drill.

Edit

Step 2

Milwaukee 2704-20 Control Switch Replacement: step 2, image 3 of 3

Remove the indicated screws (M3 x 16mm Pan Hd. ST T-10 Screws) with screwdriver.

Edit

Step 3

Milwaukee 2704-20 Control Switch Replacement: step 3, image 3 of 3

Gently lift the cover off the drill. Be careful not to force it or damage any of the internal components.
If the cover doesn't come off easily, check for any clips or latches that may be holding it in place. These can usually be released by pressing them with a small flathead screwdriver.

Edit

Step 4 Control Switch

Milwaukee 2704-20 Control Switch Replacement, Control Switch: step 4, image 1 of 3

Milwaukee 2704-20 Control Switch Replacement, Control Switch: step 4, image 2 of 3

Milwaukee 2704-20 Control Switch Replacement, Control Switch: step 4, image 3 of 3

Remove the control switch.
It is not attached to anything and should slide out easily. Take note of orientation and be sure to replace it in the same position.

Edit