Fix Your Stuff Community Store

Milwaukee Hex Impact Driver 2750-20 Directional Switch Replacement

Introduction

The following repair guide shows how to remove and replace the directional switch in a Milwaukee Hex Impact Driver 2750-20.

What you need

  1. Milwaukee Hex Impact Driver 2750-20 Directional Switch Replacement, Outer Casing: step 1, image 1 of 1

    • Remove the five T9 15.5 mm screws.

    • Remove the single T9 19.5mm screw.

    • Remove the two T9 37mm screws.

    Edit

  3. Milwaukee Hex Impact Driver 2750-20 Directional Switch Replacement: step 2, image 1 of 1

    • Remove the drill casing to expose the drill's interior parts.

    Edit

  4. Milwaukee Hex Impact Driver 2750-20 Directional Switch Replacement, Directional Switch: step 3, image 1 of 3 Milwaukee Hex Impact Driver 2750-20 Directional Switch Replacement, Directional Switch: step 3, image 2 of 3 Milwaukee Hex Impact Driver 2750-20 Directional Switch Replacement, Directional Switch: step 3, image 3 of 3
    Tool used on this step:
    Tweezers
    $4.99
    Buy

    • Remove the trigger assembly completely.

    • Remove the directional switch by lifting upward using a pair of tweezers, clearing the alignment pole on the trigger assembly.

    • Insert a new directional switch by aligning the hole on the switch with the pole on the trigger.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 13

All Time: 949