Fix Your Stuff Community Store

Ridgid R175RNE Magazine Replacement

Introduction

If your Ridgid R175RNE pneumatic coil nailer magazine is cracked or is otherwise no longer able to hold nails, then follow this guide to learn how to replace the magazine.

The magazine is what holds the coil of nails prior to them being fired, and is located directly below the firing mechanism.

Caution: Be sure that there are no nails present in the magazine before removing it.

What you need

  1. Ridgid R175RNE Magazine Replacement, Magazine: step 1, image 1 of 1

    • Disconnect the nailer from the air compressor before beginning.

    • Set the nailer down with the nosepiece facing to the left.

    Edit

  3. Ridgid R175RNE Magazine Replacement: step 2, image 1 of 1

    • Remove the single 5/32" hex screw that secures the magazine to the lower portion of the handle.

    Edit

  4. Ridgid R175RNE Magazine Replacement: step 3, image 1 of 1

    • Give the magazine a slight tug to detach it from the upper firing assembly.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 18

All Time: 44