Skip to main content

Intro History: Xiaomi Mi 9T Pro Battery Replacement

Edit by Dominik Schnabelrauch

Edit approved by Dominik Schnabelrauch

Before
After
Unchanged
Device
Xiaomi Mi 9T Pro
Type
replacement
Thing
Battery
Title
Xiaomi Mi 9T Pro Battery Replacement
Introduction
Use this guide to replace a worn-out or dead battery in your Xiaomi Mi 9T Pro.
If your battery is swollen, [[What to do with a swollen battery|take appropriate precautions|new_window=true]].
***For your safety, discharge your battery below 25% before disassembling your phone.*** This reduces the risk of a dangerous thermal event if the battery is accidentally damaged during the repair.
You’ll need replacement adhesive to reattach components when reassembling the device.
Time Required Min
40 minutes
Time Required Max
1 hour
Imageid
Before
After
Difficulty
Moderate
Conclusion
If possible, turn on your device and test your repair before installing new adhesive and resealing.
For optimal performance, [[Battery Calibration|calibrate your newly installed battery|new_window=true]] after completing this guide.
[guide|113604|Secure the new battery with pre-cut adhesive|new_window=true] or double-sided adhesive tape. In order to position it correctly, apply the new adhesive into the device at the places where the old adhesive was located, not directly onto the battery. Press the new battery firmly into place.
Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
***To reassemble your device, follow these instructions in reverse order.*** During reassembly apply new adhesive where necessary after cleaning the relevant areas with isopropyl alcohol (>90%).
Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].
Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair|basic troubleshooting]], or ask our [link|https://www.ifixit.com/Answers/Device/Xiaomi%20Mi%209T%20Pro|Answers community] for help.
Author
Public
No

Guide Prerequisites

Tools

  • ESD Safe Blunt Nose Tweezers x1 added.
  • iOpener x1 added.
  • Suction Handle x1 added.
  • iFixit Opening Picks (Set of 6) x1 added.
  • Plastic Cards x1 added.
  • Microfiber Cleaning Cloths x1 added.
  • Isopropyl Alcohol (90% or Greater) x1 added.
  • Heat Gun x1 added.
  • Spudger x1 added.
  • Phillips #00 Screwdriver x1 added.

Parts

  • Tesa 61395 Tape x1 added.
  • iFixit Adhesive Remover x1 added.

Flags

  • In Progress added.
  • Featured Guide added.

Steps

Step #: 1
Before
After
Step #: 2
Before
After
Step #: 3
Before
After
Step #: 4
Before
After
Step #: 5
Before
After
Step #: 6
Before
After