Changes to Step #2
Edit by Alex Diaz-Kokaisl —
Edit approved by Alex Diaz-Kokaisl
- Before
- After
- Unchanged
Step Lines
| - | [* black] Push the blue handle away from the hinge to engage opening mode. |
|---|---|
| - | [* black] Turn the handle clockwise until you see the cups start to stretch. |
| - | [* icon_note] Make sure the suction cups [link|https://guide-images.cdn.ifixit.com/igi/bEmDKjgQ2wnEDpSe.full|remain aligned to each other|new_window=true]. If they begin to slip out of alignment, loosen the suction cups slightly and realign the arms. |
| - | [* black] Wait one minute to give the adhesive a chance to release and for the bottom of the screen to open. |
| - | [* black] Insert an opening pick under the screen when the Anti-Clamp creates a large enough gap. |
| - | [* icon_note] If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle clockwise half a turn. |
| - | [* icon_caution] Don't crank more than a half a turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you. |
| - | [* black] ***Skip the next two steps.*** |
| + | [* black] Pull the blue handle forwards to lock the arms. |
| + | [* black] Turn the handle clockwise 360 degrees or until the cups start to stretch. |
| + | [* icon_note] Make sure the suction cups [link|https://guide-images.cdn.ifixit.com/igi/BSluctHhVVqhGtfj.full|remain aligned with each other|new_window=true]. If they begin to slip out of alignment, loosen the suction cups slightly and realign the arms. |