Fix Your Stuff Community Store

Changes to Step #3

Edit by Samuel Frazee —

Edit approved by Samuel Frazee

Before
After
Unchanged

Step Lines

-[* black] Remove the white connector by pinching the tab and pulling up.
-[* black] Remove the black connector by pulling the two sides apart.
-[* black] Remove the green, yellow, and blue cables by puling back the plastic casing and pulling apart.
-[* black] Repeat the above steps on the other side of the device to remove the other circuit board.
+[* black] Disconnect the following wires connecting the circuit boards to the sensors and motors:
+ [* black] Disconnect the white connectors by pinching the tab and pulling up on the connectors.
+ [* black] Disconnect the black connectors by pulling the two sides apart.
+ [* black] Disconnect the green, yellow, and blue cables by pulling back the plastic shielding and pulling the ends apart.