Changes to this Step
Edit by kuljinder kaur dhami —
Edit approved by kuljinder kaur dhami
- Before
- After
- Unchanged
Step Lines
| - | [* black] Please note this step is only possible after Step 1 from the tech guide on "Replacement of Battery" has been complete. |
|---|---|
| - | [* black] Locate the Ribbon Cable. |
| - | [* black] Using the Phillips #0 screwdriver, remove the J0mm screws. |
| - | [* black] Remove the small lid with using a little bit of force, |
| - | [* black] Remove the rode. |
| - | [* black] You can now replace the ribbon cable. |
| + | [* black] Please note this step is only possible after Step 1 and Step 2 from the tech guide on "Replacement of Battery" has been complete. |
| + | [* black] Locate the Ribbon Cable which is circled in the first picture. The rectangular frame holds the ribbon cable, lens, and spindle motor. The rectangular frame is connected by the white ribbon with blue stripes to the white connector which is circled in first picture. |
| + | [* black] Detach the rectangular frame from the bottom lid by taking the small white ribbon out of the white connector. |