Fix Your Stuff Community Store

Changes to Step #12

Edit by Vincent —

Edit approved by BenZ78

Before
After
Unchanged

Step Lines

[* black] Everything is completed and ready to be reassembled. The on / off switch is soldered, the adjusting screws are screwed in and the circuit board is attached to the case with both screws.
-[* icon_reminder] (Second photograph) Make sure that the pin on the support of the circuit board is engaged in the guide on the knob (marked by the red rectangle). If you turn the knob, the circuit board needs to be able to move up and down a bit, otherwise the machine will not work later!
+[* red] Make sure that the pin on the support of the circuit board is engaged in the guide rail on the knob (marked by the red rectangle in the second picture). If you turn the knob, the circuit board needs to be able to move up and down a bit, otherwise the machine will not work!