Skip to main content

Changes to Step #12

Edit by Vincent

Edit approved by VauWeh

Before
After
Unchanged

Step Lines

+[* black] Everything is completed and ready to be reassembled. The on / off switch is soldered, the adjusting screws are screwed in and the circuit board is attached to the case with both screws.
+[* icon_reminder] (Second photograph) Make sure that the pin on the support of the circuit board is engages in the guide on the knob (marked by the red rectangle). If you turn the knob, the circuit board has to move up and down a bit, otherwise the machine will not work later!