Changes to Step #13
Step Lines
| [* black] Adjusting of the speed control after repair: | |
| [* black] Turn both adjustment screws only until you can feel them flush with your fingertips on the rear side of the screw holes. Then turn the screws two turns more. | |
| [* black] Set the speed adjuster to the lowest setting. | |
| [* icon_caution] Attention: high voltage, don't reach with your fingers into the motor. | |
| [* black] Plug in. | |
| - | [* black] The motor should run slowly |
| + | [* black] The motor should run slowly. The correct speed for the planetary drive ist 60 rpm. |
| [* black] Adjust the speed by turning the adjustment screws evenly. | |
| [* black] Remove the power cord and reassemble your device following the steps in reverse order. |