Skip to main content

Changes to Step #13

Edit by VauWeh

Edit approved by VauWeh

Before
After
Unchanged

Step Lines

+[* black] Adjusting of the speed control after repair:
+ [* black] Turn both adjustment screws in, until you can feel them using your fingertips on the rear side of the screw holes. Then turn the screws two turns more.
+ [* black] Put the speed adjuster in the lowest position.
+ [* icon_caution] Attention: high voltage, don't touch with your fingers into the motor.
+ [* black] Plug in.
+ [* black] The motor should run slowly.. The correct speed for the planet gear ist 60 rpm.
+ [* black] Adjust the speed by turning the adjustment screws.
+ [* black] Remove the power cord and reassemble your device following the steps in reverse order.