Fix Your Stuff Community Store

Changes to Step #10

Edit by Taylor Dixon —

Edit approved by Taylor Dixon

Before
After
Unchanged

Step Lines

[* icon_reminder] To reinstall the back cover:
[* black] Use tweezers to peel away any remaining adhesive from both the back cover and the phone's chassis.
[* black] Clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth. Swipe in one direction only, not back and forth. This will help prep the surface for the new adhesive.
[* icon_note] ***Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.***
[* black] Peel away the replacement adhesive's liner, align it with the back of the phone, and press it into place.
[* black] Remove any remaining liners, and replace the back cover.
[* black] After installing the rear cover, apply strong, steady pressure to your phone for several minutes to help the adhesive form a good bond, such as by placing it under a stack of heavy books.
-[* icon_note] If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.
+[* icon_note] You can also reinstall the rear cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the rear cover from sitting down flush. After installation, heat the cover and apply pressure to secure it. The phone won't be waterproof, but the residual adhesive is usually more than strong enough to hold.