Fix Your Stuff Community Store

Changes to Step #8

Edit by Arthur Shi —

Edit approved by Arthur Shi

Before
After
Unchanged

Step Lines

-[* black] We won’t stop with the convenient to remove modules and pull out our [product|IF145-039-4|Torx T5|new_window=true] screwdriver and an opening pick to take a look inside.
+[* black] Not satisfied with just removing the modules, we bust out our [product|IF145-039-4|Torx T5|new_window=true] screwdriver and an opening pick and ''tear down'' even more.
[* black] Starting with the top module:
[* black] The 8 MP ƒ2.0 front camera and earpiece speaker are separately removable
[* black] The headphone jack as well as the proximity and ambient light sensors are soldered onto the breakout board.
-[* black] The camera module carries a separately removable 12 MP ƒ1.8 camera with an SONY IMX363 Exmor RS sensor. The flashlights are solder onto the breakout board.
-[* black] The bottom module contains the vibration motor and a soldered on USB-C port and microphone.
-[* black] The speaker module is the loneliest of the modules clining onto the bottom module with its two contacts.
+[* black] The camera module carries a separately removable 12 MP ƒ1.8 camera with an SONY IMX363 Exmor RS sensor. The flash LEDs are soldered onto the breakout board.
+[* black] The bottom module contains the vibration motor, a microphone, and a soldered-on USB-C port.
+[* black] The loudspeaker module is the loneliest of the modules clinging onto the bottom module with its two contacts.