Fix Your Stuff Community Store

Changes to Step #7

Edit by Tarun Thiruma —

Edit approved by Tarun Thiruma

Before
After
Unchanged

Step Lines

-[* black] Slide the motor along its mounting slots towards the sander's handle until there is some slack in the fan belt.
-[* icon_reminder] During reassembly, slide the motor back to its original position before tightening the motor mount nuts again. Check that the belts are properly tensioned before securing the belt housing back into place.
+[* black] Slide the motor along its mounting slots towards the sander's handle until the fan belt is detensioned.
+[* icon_reminder] During reassembly, slide the motor back to its original position before tightening the motor mount nuts. Check that the belts are properly tensioned before securing the belt housing back into place.