Changes to Step #1
Edit by Tarun Thiruma —
Edit approved by Tarun Thiruma
- Before
- After
- Unchanged
Step Lines
| + | [* icon_note] Gently fold the display over away from the rest of the iPod, taking care not to disconnect or break any of the ribbon cables. Set the two halves flat on a table or bench. |
|---|---|
| + | [* black] ***If your iPod has a black home button assembly rather than the orange one shown here, you can skip this step.*** The button is not attached to the LCD plate and does not need to be removed to complete the repair. |
| + | [* black] Use a plastic opening tool to pry the home button switch up from the LCD plate. |
| + | [* black] It may be necessary to use a heat gun or hair dryer to soften the adhesive on the back of the home button. Always use a low heat setting. |
| + | [* icon_caution] Do not attempt to remove the home button switch, as it is connected to components below the LCD plate. |
Image 1
No previous image
Added
Image 2
No previous image
Added