Fix Your Stuff Community Store

Changes to Step #1

Edit by Tiny Machines 3D —

Edit approved by Tiny Machines 3D

Before
After
Unchanged

Step Lines

[title] Preparing / Disassembly 1a.
[* icon_caution] After moving Z to 250mm above the bed and removing filament, Power Off, Power Cables UNPLUGGED!
[* icon_note] Remove printhead cable and control box and set aside.
- [* icon_reminder] You will need to be able to access the back of the machine as well as the front. Give yourself enough room to rotate the machine.
- [* icon_note] If you have access to compressed air, blow the machine off. Use this time to clean the machine and give yourself good lighting to look over all the components on the machine.
+ [* icon_reminder] You will need access to the back of the machine as well as the front. Give yourself enough room to rotate the machine if not work all they way around.
+ [* icon_note] If you have access to compressed air, blow the machine off. Use this time to clean the machine and give yourself good lighting to look over all the components thoroughly.
[* black] Using a M2.5 hex and 8mm open end wrench, loosen the bottom inner wheel eccentric locknut. Back it off a few turns.
[* black] Using a 7mm closed end wrench hold the nylock nut on the front of the X/Z bracket and loosen the eccentric wheel shaft with the M2.5 hex.
[* black] Fully remove both lower inner wheels. They will not be used.
[* icon_note] 3 points is superior to 4 in this case.