Changes to Step #2
Edit by Tiny Machines 3D —
Edit approved by Tiny Machines 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Disassembly 1a. |
|---|---|
| + | [* black] Using a M2.5 hex and 8mm open end wrench, loosen the bottom inner wheel eccentric locknut. Back it off a few turns. |
| + | [* black] Using a 7mm closed end wrench hold the nylock nut on the front of the X/Z bracket and loosen the eccentric wheel shaft with the M2.5 hex. |
| + | [* black] Fully remove both lower inner wheels. They will not be used. |
| + | [* icon_note] 3 points is superior to 4 in this case. |