Changes to Step #6
Edit by Tiny Machines 3D —
Edit approved by Tiny Machines 3D
- Before
- After
- Unchanged
Step Lines
| - | [title] Install the X Belt |
|---|---|
| + | [title] Assembly 1c. Install the X Belt |
| [* icon_note] You will need a minimum of 4 cable ties, a pair of needle nose pliers and a pair of flush cut pliers. | |
| [* icon_note] Formbot Raptor owners will only reuse the X Motor/ bracket. Vivedino Raptor 2 owners will reuse the X Motor/ Bracket and X belt. | |
| [* black] Route one end of the belt through the front of the belt slot on the X Carriage Plate and fold over about ½”. Using a cable tie, secure that end in place, making sure the teeth on the belt mesh together to hold tight. | |
| [* black] Run the belt around the opposite side pulley and back to the open slot repeating the process, this time pulling the belt tight with your hands or needle nose pliers before securing with a cable tie. |