Changes to Step #5
Edit by Jamie Bell —
Edit approved by Jamie Bell
- Before
- After
- Unchanged
Step Lines
| + | [* black] Lift the back end of the cover |
|---|---|
| + | [* icon_caution] The cover is connected to the body by a cable. Don't open the cover all the way until this cable is unplugged! |
| + | [* red] Unplug the 6-pin connector, then pry along the edges to release the plastic clips holding the top down |
| + | [* black] Remove the cover |
| + | [* icon_note] The clips at the nose of the drone require some extra pressure to release |
Image 1
No previous image
Added
Image 2
No previous image
Added