Changes to Step #5
Edit by Jamie Bell —
Edit approved by Jamie Bell
- Before
- After
- Unchanged
Step Lines
| [* black] Lift the back end of the cover | |
| [* icon_caution] The cover is connected to the body by a cable. Don't open the cover all the way until this cable is unplugged! | |
| - | [* red] Unplug the 6-pin connector, then pry along the edges to release the plastic clips holding the top down |
| + | [* red] Unplug the 6-pin GPS connector, then pry along the edges to release the plastic clips holding the top down |
| [* black] Remove the cover | |
| [* icon_note] The clips at the nose of the drone require some extra pressure to release |