Fix Your Stuff Community Store

Changes to Step #2

Edit by Robert Boyd —

Edit approved by Robert Boyd

Before
After
Unchanged

Step Lines

-[* red] Loosen the two set screws on the middle flange bearing with a 1/8 inch hex key.
- [* icon_note] These set screws require a long hex key to loosen. These screws can be accessed from the front of the floor stripper or from the slots on the side of the frame.
+[* red] Use a 1/8 inch hex key to loosen the two set screws on the middle flange bearing.
+ [* icon_note] These set screws require either a long hex key or an extension to reach. They can be accessed from the front of the floor stripper or from the slots on either side of the frame.