Fix Your Stuff Community Store

Changes to Step #3

Edit by Robert Boyd —

Edit approved by Robert Boyd

Before
After
Unchanged

Step Lines

[* red] Remove the two 9/16 inch bolts nuts securing the upper flange bearing to the frame.
- [* icon_note] If you are unable to fit a 9/16 inch socket on the nuts due to the cam shaft pulley, attempt to remove the
+ [* icon_note] If you are unable to fit a 9/16 inch socket on the nuts due to the cam shaft pulley, try using a 9/16 wrench.
[* icon_note] If the bolt twists without loosening, use a 9/16 inch wrench to hold the bolt head from underneath.