Fix Your Stuff Community Store

Changes to Step #3

Edit by Robert Boyd —

Edit approved by Robert Boyd

Before
After
Unchanged

Step Lines

-[* red] Remove the two 9/16 inch bolts securing the upper flange bearing to the frame.
- [* icon_note] If you are unable to fit a 9/16 inch socket on the nuts due to the cam shaft pulley, try using a 9/16 wrench.
- [* icon_note] If the bolt twists without loosening, use a 9/16 inch wrench to hold the bolt head from underneath.
+[* red] Use a 9/16 inch socket to remove the two nuts securing the upper flange bearing to the frame.
+ [* icon_note] If you are unable to fit a socket on the nuts due to the cam shaft pulley, try using a wrench.
+ [* icon_note] If the bolts spin without loosening, use a 9/16 inch wrench to hold the bolt head from underneath."