Changes to Step #4
Edit by Kyle Smith —
Edit approved by Kyle Smith
- Before
- After
- Unchanged
Step Lines
| [title] Disconnect the battery | |
| - | [* icon_note] The battery connector is attached to the underside of the display cable bracket. |
| - | [* black] Insert the flat end of a spudger under the display cable bracket and lift up to disconnect the battery connector from the logic board. |
| + | [* icon_note] The battery press connector is attached to the underside of the display cable bracket on the screw hole side. |
| + | [* black] Insert the flat end of a spudger under the display cable bracket and lift up to disconnect the battery press connector from the logic board. |
| + | [* icon_caution] Take care to pry only under the edge of the connector to prevent damaging the socket itself and surrounding components. |
| + | [* icon_reminder] To re-attach [guide|25629|press connectors|stepid=70308|new_window=true] like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage. |
| [* icon_caution] Don't try to remove the display cable bracket as it's attached to the battery by the battery cable. |