Changes to Step #3
Edit by Sam Goldheart —
Edit approved by Sam Goldheart
- Before
- After
- Unchanged
Step Lines
| - | [* black] Our true and tested heat&vise combo does the trick to get the inside facing cap off. |
|---|---|
| - | [* black] While we spot a tiny battery pouch on the inside … |
| - | [* black] … the driver is seated in the cap. |
| - | [* black] At first sight there is no obvious way at all on how to continue from here. Short cables, adhesive and no hint on how to continue from this point. |
| + | [* black] We're a bit nervous about the glued-in motherboard we spotted, so we opt to [link|https://youtu.be/3vY3wuE7WVU?t=125|put the squeeze|new_window=true] on the speaker portion of these buds. |
| + | [* black] Pressure and heat makes for teardown diamonds, we pop the driver casing open! |
| + | [* black] That said, while we peep a tiny battery pouch deep inside, it's mostly tiny cables and soldered wire inside |
| + | [* black] Where to go from here? |
| + | [* icon_note] Too early to say we miss [link|https://www.youtube.com/watch?v=4Uq1v64_RCA&t=79s|Fairphone's visual aids] and [https://youtu.be/4Uq1v64_RCA?t=155?|standard screws|new_window=true]? |