Changes to Step #3
Edit by Clay Eickemeyer —
Edit approved by Clay Eickemeyer
- Before
- After
- Unchanged
Step Lines
| - | [* black] Insert wisdom here. |
|---|---|
| + | [* black] Hold the back glass upright with one hand and rotate it just enough to reveal the [link|https://guide-images.cdn.ifixit.com/igi/JTgBIs4pnklXuCQn.huge|battery press connector|new_window=true] just below the volume buttons. |
| + | [* black] Use the tip of an opening pick to pry up and disconnect the battery press connector from the logic board. |
| + | [* icon_note] To reconnect a [guide|25629|press connector|stepid=70308|new_window=true], align it over its socket and gently press down on one side until it clicks into place, then press down on the other side. Make sure it sits flat, as the insulating rubber around the sockets might prevent it from connecting fully. |