Fix Your Stuff Community Store

Changes to this Step

Edit by Spencer Day —

Edit approved by Spencer Day

Before
After
Unchanged

Step Lines

[* black] Insert the flat end of a spudger between the board and the lower shield plate, near the power button.
[* black] Twist the spudger to lift the prongs under the board out of the power supply socket.
[* icon_note] You should feel the prongs slide out.
-[* icon_reminder] During reassembly, press down on the corner of the board to fully seat the prongs in the power supply. You should feel them slide into place.
+[* icon_reminder] During reassembly, press down on the corner of the board to fully seat the prongs in the power supply—you should feel them slide into place.