Changes to this Step
Edit by Spencer Day —
Edit approved by Spencer Day
- Before
- After
- Unchanged
Step Lines
| [* black] Insert the flat end of a spudger between the board and the lower shield plate, near the power button. | |
| [* black] Twist the spudger to lift the prongs under the board out of the power supply socket. | |
| [* icon_note] You should feel the prongs slide out. | |
| - | [* icon_reminder] During reassembly, press down on the corner of the board to fully seat the prongs in the power supply—you should feel them slide into place. |
| + | [* icon_reminder] ***Is this necessary during reassembly? Could it put uneven pressure on the board?*** During reassembly, press down on the corner of the board to fully seat the prongs in the power supply—you should feel them slide into place. |