Fix Your Stuff Community Store

Changes to Step #7

Edit by Sam Goldheart —

Edit approved by Sam Goldheart

Before
After
Unchanged

Step Lines

-[* icon_note] Make sure the suction cup is firmly attached to the front panel assembly.
-[* black] While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the front panel assembly from the rear case.
-[* icon_note] Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices.
-[* black] With a plastic opening tool, begin to gently pry the rear case down, away from the display assembly, while you pull up with the suction cup.
-[* icon_note] There are several clips attaching the front panel assembly to the rear case, so you may need to use a combination of the suction cup and plastic opening tool to free the front panel assembly.
+[* icon_caution] The display is attached to the phone via clips and several ribbon cables, you will release the clips and ***separate the phone only enough to disconnect the cables***. Go slowly and carefully to avoid damage.
+[* icon_note] Make sure the suction cup is firmly attached to the front panel assembly near the home button.
+[* black] While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the home button end of the display from the rear case.
+[* black] With a plastic opening tool, gently pry the edges of the rear case down, away from the display assembly, while you pull up with the suction cup.
+[* icon_caution] Take your time and apply firm, constant force. The 5s display assembly is a much tighter fit than most devices.