Changes to Step #17
Edit by iGuys —
Edit approved by Kyle Wiens
- Before
- After
- Unchanged
Step Lines
| [* black] Remove the following screws securing the front panel assembly cable bracket to the logic board: | |
| [* red] Two 1.7 mm Phillips #000 screws | |
| [* orange] One 1.2 mm Phillips #000 screw | |
| [* yellow] One 1.3 mm Phillips #000 screw | |
| [* icon_note] This 1.3 mm screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing. | |
| + | [* icon_caution] It is especially important to keep track of your screws in this step for reassembly. Accidentally using one of the 1.7 mm screws in the bottom right hole will very likely result in major damage to the logic board. |