Changes to Step #17
Edit by Calion —
Edit declined by Evan Noronha
- Before
- After
- Unchanged
Step Lines
| [* black] Remove the following screws securing the front panel assembly cable bracket to the logic board: | |
| [* red] Two 1.7 mm Phillips #000 screws | |
| + | [* icon_note] One of these 1.7 mm screws tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing. |
| [* orange] One 1.2 mm Phillips #000 screw | |
| [* yellow] One 1.3 mm Phillips #000 screw | |
| - | [* icon_note] This 1.3 mm screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing. |
| [* icon_caution] It is especially important to keep track of your screws in this step for reassembly. Accidentally using the 1.3 mm screw or one of the 1.7 mm screws in the bottom right hole will result in significant damage to the logic board causing the phone to no longer boot properly. | |
| [* icon_caution] Be careful not to over-tighten the screws. If they don't fit easily when you are securing them, they may be the wrong size, don't force them |