Changes to Step #17
Step Lines
| [* black] Remove the following screws securing the front panel assembly cable bracket to the logic board: | |
| [* red] Two 1.7 mm Phillips #000 screws | |
| [* orange] One 1.2 mm Phillips #000 screw | |
| [* yellow] One 1.3 mm Phillips #000 screw | |
| - | [* icon_note] |
| + | [* icon_note] The upper right screw is non-ferrous and will not be attracted to a magnetized screwdriver. This is to prevent interference with the magnetometer which is located nearby. Take care not to lose it when removing. |
| [* icon_caution] It is especially important to keep track of your screws in this step for reassembly. Accidentally using the 1.3 mm screw or one of the 1.7 mm screws in the bottom right hole will result in significant damage to the logic board causing the phone to no longer boot properly. | |
| [* icon_caution] Be careful not to over-tighten the screws. If they don't fit easily when you are securing them, they may be the wrong size, don't force them |