Changes to Step #6
Edit by Jeff Suovanen —
Edit approved by Jeff Suovanen
- Before
- After
- Unchanged
Step Lines
| [* black] Remove the following screws from the logic board: | |
| [* red] One 2.4 mm Phillips #000 screw | |
| [* icon_reminder] This screw also holds a small metal contact beneath the logic board. It's held in place underneath a plastic bracket, but if you see it slipping out, refer to [guide|20246|this step|stepid=72613|new_window=true] to remove it. | |
| [* orange] Two 2.3 mm Phillips #000 screws | |
| [* yellow] Four 2.8 mm standoff screws | |
| - | [* icon_note] Use a small flathead screwdriver to remove these standoff screws. |
| - | [* icon_reminder] During reassembly, you can use the tip of a spudger to get the standoff screw started. |
| + | [* icon_note] Standoff screws are best removed with a [product|IF145-388-5|standoff screwdriver|new_window=true] or [product|IF145-343|standoff driver bit]. A small flathead screwdriver can also do the job—but use extra caution to ensure it doesn't slip and damage surrounding components. |