Changes to Step #6
Edit by Sam Goldheart —
Edit approved by Sam Goldheart
- Before
- After
- Unchanged
Step Lines
| [* black] Remove the following screws from the logic board: | |
| [* red] One 2.4 mm Phillips #000 screw | |
| [* orange] Two 2.3 mm Phillips #000 screws | |
| [* yellow] Four 2.8 mm standoff screws | |
| [* icon_note] Use a small flathead screwdriver to remove these standoff screws. | |
| + | [* icon_reminder] During reassembly, you can use the tip of a spudger to get the standoff screw started. |