Fix Your Stuff Community Store

Changes to Step #22

Edit by Evan Noronha —

Edit approved by Evan Noronha

Before
After
Unchanged

Step Lines

[* icon_note] In the next steps, you will use an iOpener to apply heat to the rear case of the iPad to soften adhesive holding the logic board in place.
-[* icon_note] As you Reheat and place the iOpener in each of the indicated locations, leave it in place for at least a minute to soften the adhesive through the rear case.
+[* icon_note] As you reheat and place the iOpener in each of the indicated locations, leave it in place for at least a minute to soften the adhesive through the rear case.
[* red] The adhesive is in the form of six pieces of black foam tape—refer to this step as you work at heating and prying to keep track of where each piece is located.