Changes to Step #7
Edit by Lukas Selch —
Edit approved by Sam Goldheart
- Before
- After
- Unchanged
Step Lines
| - | [* black] Remove the following five screws securing the Wi-Fi antenna to |
|---|---|
| + | [* black] Remove the following five screws securing the Wi-Fi antenna to the logic board: |
| [* red] One 2.3 mm Phillips | |
| [* orange] Two 1.6 mm Phillips | |
| [* yellow] One 1.4 mm Phillips | |
| [* green] One 4.8 mm Phillips | |
| [* icon_caution] When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. ''This is to ensure there is no mix-up, and avoid rendering the LCD and digitizer useless.'' | |
| [* icon_caution] Also make sure to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the Wi-Fi antenna and is often the culprit if you are having bad Wi-Fi reception after reassembly. |