Fix Your Stuff Community Store

Changes to Step #27

Edit by Sam Goldheart —

Edit approved by Sam Goldheart

Before
After
Unchanged

Step Lines

[* icon_caution] Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
-[* black] Flip the iPad back over and insert a plastic card between the logic board side, speaker end of the battery and the rear case.
+[* black] Insert a plastic card under the battery from the Lightning cable connector end of the iPad.
[* icon_note] If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.