Changes to Step #45
Edit by Sam Goldheart —
Edit approved by Sam Goldheart
- Before
- After
- Unchanged
Step Lines
| + | [* black] Carefully insert the flat end of a spudger between the rear-facing camera and the top of the logic board. |
|---|---|
| + | [* black] Pry the logic board up enough to grab it with your fingers. |
| + | [* icon_caution] Be extremely careful not to damage the rear-facing camera cable, or any logic board components. |
| + | [* icon_note] If the logic board does no lift easily, there may still be adhesive holding it to the rear case. Try sliding the pick farther before prying again. |
Image 1
No previous image
Added
Image 2
No previous image
Added