Changes to Step #11
Edit by David Mitchell —
- Before
- After
- Unchanged
Step Lines
| - | [* black] Remove the following 8 screws |
|---|---|
| + | [* black] Remove the following 8 screws and organize them on the tape on your bench. |
| [* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear panel. | |
| [* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera. | |
| [* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker. | |
| [* black] Note for re-assembly: | |
| - | [* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place. |
| + | [* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place. The strap fits into a slot on the camera. |
| [* black] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the camera |