Fix Your Stuff Community Store

Changes to Step #11

Edit by Alex Jansen —

Edit approved by Alex Jansen

Before
After
Unchanged

Step Lines

[* black] Remove the following 8 screws:
- [* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear panel.
+ [* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.
[* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
[* black] Note for re-assembly:
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
[* black] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the camera