Changes to Step #4
Edit by erpel —
- Before
- After
- Unchanged
Step Lines
| [* black] Remove following two screws: | |
| [* red] One 8.6 mm Phillips screw | |
| [* orange] One 3.9 mm Phillips screw | |
| [* black] Carefully rotate the AirPort/Bluetooth board housing (with AirPort/Antenna cables still attached) out of the lower case. | |
| + | [* black] Note that there is a small nose on the short flat side of the metal assembly, that has to go under the upper case frame on the outer rim of the case during reassembly. |