Changes to Step #1
Edit by Sales Cameraparts4you —
Edit approved by Sales Cameraparts4you
- Before
- After
- Unchanged
Step Lines
| + | [title] Release the Main PCB Flex Cables |
|---|---|
| + | [* yellow] Pull the 3 flex cables out using flat needle nose pliers (it is easier to slide open the black clamps prior to pulling). These are sliding clamps not flip (up) clamps. |
| + | [* green] Pull the single cable from the socket. This is a friction fit socket. |
| + | [* light_blue] Flip up the Cable clamp (picture #2) using a spudger as shown in the previous pages and release the cable. |
| + | [* violet] Flip up the Cable Clamp (picture #3) using a spudger and release the cable. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added